Team Paracord.euAug 10, 2022

Paracord

Tutorial

Dog collar

Share

The Double KBK Bar is designed by J.D. Lenzen. This knot is about 0.9 cm thick and 4 cm wide when using paracord type 3. The knot itself is not difficult, but the finishing off can be a little different than you are used to.

For the Double KBK Bar you use three colors of paracord. You can use different kinds of closures or spacers, in the tutorial we use two D-rings of 28 mm.

A single setup (Kosmetik 2.0) is used here, this is also safe to use for dog collars.

After you have made the Kosmetik 2.0 with color 1, you attach the two loose strands with a temporary knot to the closure.

Then add the other colors to the setup.

Color 1: Taupe, color 2: Soft Skies Blue and color 3: Vanilla Yellow. The colors in the photos vary slightly from reality due to editing.

Measure again whether the length of your setup is correct and check whether the two strands of each color are the same length.

1. Let the two strands of color 2 pass over color 1 and then under color 3.
2. Now let the strands of color 3 pass under the two right-hand strands of color 1, cross over color 2 and pass under the other two strands of color 1 and bring them to the left over color 2.

1. Tighten all the strands.
2. Bring color 2 to the left over the strands of color 1 and under color 3.

1. Bring color 3 to the right, passing under the strands of color 1 and over the strands of color 2 as shown in the photo.
2. Now pull all the strands.

Repeat the six steps above until your knotwork is the desired length.

After you have knotted the desired length it is time to start backstitching. This works a little differently with this knot than with most other knots. Here we will show you how to mimic the setup when finishing off.

Make sure you have these tools at hand:

• Scissors
• Tea spoon
• Paracord needle or crochet hook

1. Undo the temporary knots of color 1.

Turn your knotwork over. Use a paracord needle or a crochet hook to pass the loose strands of color 1 through the cow hitch knot and under some loops of color 3. You can see how the strands coincide with other strands of color 1 in the process.

1. The right-hand strand of color 3 is now also stitched back under a couple of loops of color 3.
2. Turn your knotwork over again, so that the front is facing you.

1. Bring the other strand of color 2 to the back through the D-ring.
2. Let the strand come to the front again and go around itself. Insert it through the D-ring from behind.

1. Now insert the strand through the loop you made.
2. Tighten. You can see that you have made an extra cow hitch knot.

1. Turn your knotwork over again. Now stitch back the strand of color 2 under the strands of color 3.
2. Stitch back the upper strand of color 3 under some of the strands.

1. Turn your knotwork over. Now make a cow hitch knot with color 3.
2. You can see that the end now looks the same as the beginning with the four cow hitch knots in a row.

1. Turn your knotwork over. Stitch back the last strand of color 3 under some strands.
2. Now cut all the strands, burn the ends and push them flat (use a teaspoon for this, for instance).

We would like to thank the designer J.D. Lenzen for giving us permission to use this knot.